deck skirting uneven ground

Deck Building - P4 - How to Install Lattice on a Deck

After Building my Deck it is time to install some Lattice to give that deck a nice Clean Look. Here i will show you how to cut a strange angle into the lattice to follow the ground. Category

Get Quotes / Contact Us

Building Deck Skirting - HammerZone.com

The deck before the skirting was installed. The synthetic handrails have already made a big improvement in the appearance, but the gaping void below the deck is even more obvious. This is the south side.

Get Quotes / Contact Us

How to Install Lattice Around the Bottom of a House Home

Drive short wooden stakes into the ground immediately behind the 2-by-4s, one about every 5 feet and at every joint. Sink several inches in the ground and leave at least 4 or 5 inches above as well.

Get Quotes / Contact Us

How to Solve an Uneven Surface Deck Installation

One of the most common problems in deck installation is working on an uneven ground. However, this is a relatively easy problem to solve. There are 2 ways of solving this problem: one is to excavate the soil and put gravel in the excavated area to level the surface; the other is to build a floating deck.

Get Quotes / Contact Us

Decks.com. Deck Skirting and Fascia

Here is a nice example of how you can install skirting, fascia and an access door under your deck. The nailer board follows the ground. Install a nailer board between support posts to attach the bottom side of the skirting or install 2x4 vertical framing flush on the outside of the frame.

Get Quotes / Contact Us

Skirts: Skirt Installation DIY Deck Plans

When installing horizontal deck trim and vertical skirt that are the same thickness, over hang the deck boards the thickness of the skirt past the front faceplate and/or past the outside joists. Use a scrap of ¾ inch lumber to space your skirting above the ground.

Get Quotes / Contact Us

How to Build a Lattice Wall Beneath Your Deck how-tos DIY

Cut 2" by 2" supports to fit the length of the deck posts as well as the area along the bottom of the deck between the posts. Attach the supports using exterior-grade deck screws. As an alternative, use H-molding to seam pieces of lattice together Image 1 .

Get Quotes / Contact Us

How to Skirt a Deck - Living The Bump

Repeat the skirt board cutting and installing process, taking additional measurements if the ground is uneven. Repeat the above steps for each side of the deck; deck corners consist of two skirt boards butted perpendicular to each other and secured with the two 2-inch wood screws.

Get Quotes / Contact Us

Need help with deck skirting - Houzz

Need help with deck skirting. Brian Thompson If you don't want to surround that area with a hedge of bushes,I think the look of stone at the base of the deck would look really nice and ground the house. but I remember seeing a really nice look on a house done recently on "This Old House" where there was the similar uneven ground and

Get Quotes / Contact Us

Wonderful Deck Skirting Ideas to Use for Your Home

Deck skirting is a material attached to support post and boards below a deck. Deck skirting is used on elevated decks to conceal what is between the deck and the ground and as a base. There are several materials you can use for skirting.

Get Quotes / Contact Us

How to Skirt a Deck - Living The Bump

The skirting is attached to horizontal backer boards, which are pieces of 2-by-4 lumber that attach directly to the deck post. You'll need two courses of backing, one at the top of the post and one at the opposite end near the ground.

Get Quotes / Contact Us

Porch Skirting Vinyl Lattice Panels Porch Landscaping

Porch skirting can add immense curb appeal to your home. Nice landscaping and vinyl lattice panels are just a couple ideas for hiding unsightly piers, support columns, and joists. You can also use skirting to help keep out critters from under your porch or deck.

Get Quotes / Contact Us

Uneven Ground Siding Question - ContractorTalk

Re: Uneven Ground Siding Question did i for get to mention its a mobile home sitting on the chassis" leveled" by block, and the grade is uneven sorry for the confusion the area where i was going to side that would be uneven is where the old skirting was, but i have decided for that area just to use a vertical approach instead of horizontal

Get Quotes / Contact Us

Deck Fascia Along Uneven Ground - Building and Construction

Deck fascia along uneven ground I wanted to try and create a 'box' around the deck basically bringing the fascia board close to the ground and maybe fill in some rock to hide any small gaps. The front of the deck measures 30' across.

Get Quotes / Contact Us

Adding Wood Lattice Under Skirting Around a Deck

Print Video Transcript Danny Lipford: Installing lattice under skirting to mask off the area under a deck is a great way to improve its overall appearance. Lattice typically comes in four-foot by eight-foot sheets, so youll need vertical supports for the lattice at least every eight feet if its four feet or less above ground.

Get Quotes / Contact Us