from my chain link? I was thinking the vinyl posts would just slip over the posts left from the chain link - which are sunk into concrete. Would this work or would it be too flimsy?
If you use a good make fence the posts are cut out for the top and bottom rails to slide in, the pipe will be in the way. You also need to put each post tight on each side of the panel or you will see a space and the T and G boards will separate a bit over time,
Putting up new decorative vinyl fence panels. Now lets go back to the post sleeves and installation. Like said if the posts are in decent condition and spaced correctly than you can simply slide over new PVC posts they are hollow sleeves over the existing posts.
How to Install a Vinyl Fence Written by Gerry Rogan Wed, Jan 23, 2013. Because the fence posts in this installation are 5" square for the material, measurement back from the center would be 26 1/2". in the installers left hand in the photo above is crossed over the loose end of the string line in the installers right hand in
Installing new 8ft fence, re-using existing 4ft posts January 11, Installing a fence over 6' might take a building permit and/or permission from the neighboring owners. Restrictions in your area should be on file with your county. posted by Cranberry at 12:12 PM on January 11, 2015 .
Fence Posts . Every fence project needs posts. Whether putting vinyl post sleeves over existing wooden posts, or installing a new fence with original vinyl posts, fence posts provide the necessary support.
Install a Vinyl Fence. Gates are available to match each type of fence. Post-and-rail fencing is also available in vinyl, although the installation of that type of fence is different. Installing a vinyl fence on a slope requires the use of the step method: the fence gradually steps up the slope so that each bay section is the same
Installing a Vinyl Fence. Set the posts right and the rest is easy. Install posts that flank gates with extra care. Make sure the posts are perfectly plumb and spaced. Add a small dollop of PVC cement or silicone caulk to the tabs at the top of each cap and push the caps over each post. Photo 13: Hang the gate.